Supplied mounting plate permits secure attachment to most brands of drill presses.
Securing the table top to the mounting plate.
An opening in the table top accepts a removable wooden insert to support through-drilling.
Built-in levelling screws let you set the wooden insert flush with the table top.
3/4" dog holes let you use hold-down clamps, bench dogs or other accessories.
Sub-fences can be opened to allow off-edge drilling.
T-track on the fence accepts accessories such as the Veritas 1 1/2" flip stop (not included).
05J6820 - Veritas Large Drill-Press Table & Fence
Description
We designed our drill-press table to be compatible with most major brands of drill presses without modification
The table and fence set fits any drill press with a swing of 14" or greater (7" from bit to column) and comes supplied with all mounting hardware needed for installation in either through-slots or blind T-slots
Precisely milled from 18mm Baltic birch plywood with a low-friction laminate surface, the sturdy 15 1/2" × 23" table top provides stable support for your work
It has two keyhole slots for mounting the included fence, as well as four standard 3/4" dog holes for clamps, dogs or other accessories
To support through-drilling, an opening in the middle accepts a 4" square sacrificial wooden insert (one supplied; replacements can be easily made from any 6mm or 1/4" wooden sheet material)
The 20" machined aluminum fence permits accurate, repeatable stock positioning, and comes with hardware for mounting on the table (or in a pair of standard T-tracks or keyhole slots on other workshop fixtures)
It has a pair of laminate-clad sub-fences (each 10 1/2" long) that can be opened to allow off-edge drilling, and a T-slot track on top for mounting jigs and accessories (such as the Veritas 1 1/2" flip stop)
Straightforward to mount and use, this is a practical, well-made upgrade to a woodworking drill press